10mm S460 Structural steel Discs Circles

( Including VAT )

Enter value from 15 to 1500 step 0.1
Enter the required disc diameter in mm
Enter value to 1480 step 0.1
Enter "0" if you require NO hole, Enter "0.1" if you require a center Mark, or enter a hole diameter of at least 1x the thickness of the metal sheet/plate.
Enter value from 1 to 20000 step 1
30 days
8388607 item(s)

10mm S460 Structural steel Washers Circles Discs Blanks Profiles.

Precision plasma cut to size, deburred and linished(*) edges.

How to order

Please enter your exact dimensions of your diameter in the options above for a instant price.
If you require a washer or a hole in the middle please enter your Hole diameter in mm. Leave as 0mm for no hole.

Select if you would like a pack size of 1, 6 or 10 pieces for multiple buy discount and then add to your shopping basket to order.

Discs from thicknesses 15mm and over may require the hole to be drilled. There is no extra charge however please note the standard sizes are;
3mm 4mm 5mm 6mm 7mm 8mm 10mm 11mm 12mm 13mm 14mm 15mm 16mm 18mm 20mm 25mm 30mm 35mm 40mm and 50mm.
Above this, holes must be 3x the thickness. So on 20mm the minimum hole size is 60mm once you exceed the drill bit sizes.
Please contact us if you have requirements outside of the above, we will almost certanily be able to quote and supply you still manually.

S460 Steel
The specification EN 10025:3 covers weldable structural steels manufactured with a fine grain structure and supplied in the normalised condition or in an equivalent condition obtained by normalised rolling. There are four grades (S275, S355, S420 and S460) which indicate each grade’s minimum yield strength (in MPa) for plates 16 mm thick and below.

We will produce your order to your required dimensions. We have set this from 50mm x 50mm through to 2500mm x 1250mm.
It is possible to supply smaller or larger pieces, please get in touch if your requirements fall outside these dimensions.

(*) Larger pieces of steel may not have the edges linished, but will be de-drossed and deburred. Typically over 600mm x 600mm.
Typical tolerances for cuts are +/- 0.5mm, if you need better please get in touch for a quote.

Lakeland Steel
All diameters up to 1220mm
Metal Discs & Washers
S460 Steel
RAEX 500 Hardox wear plate
Thickness :
cs-cart license, cs-cart addons, cs-cart multivendor