Mild steel sheet plate S275JR Washers Circles Discs Blanks Profiles.
Precision plasma cut to size, deburred and linished(*) edges.
How to order
Please enter your exact dimensions of your diameter in the options above for a instant price.
If you require a washer or a hole in the middle please enter your Hole diameter in mm. Leave as 0mm for no hole.
Select if you would like a pack size of 1, 6 or 10 pieces for multiple buy discount and then add to your shopping basket to order.
IMPORTANT NOTES PLEASE READ.
Discs from thicknesses 15mm and over may require the hole to be drilled. There is no extra charge however please note the standard sizes are;
3mm 4mm 5mm 6mm 7mm 8mm 10mm 11mm 12mm 13mm 14mm 15mm 16mm 18mm 20mm 25mm 30mm 35mm 40mm and 50mm.
Above this, holes must be 3x the thickness. So on 20mm the minimum hole size is 60mm once you exceed the drill bit sizes.
Please contact us if you have requirements outside of the above, we will almost certanily be able to quote and supply you still manually.
Mild steel S275JR
S275 is a standard good quality mild steel available in sheet and plates from 1mm to 30mm in thickness through our website.
We will produce your order to your required dimensions. We have set this from 50mm x 50mm through to 2500mm x 1250mm.
It is possible to supply smaller or larger pieces, please get in touch if your requirements fall outside these dimensions.
(*) Larger pieces of steel may not have the edges linished, but will be de-drossed and deburred. Typically over 600mm x 600mm.
Typical tolerances for cuts are +/- 0.5mm, if you need better please get in touch for a quote.
No posts found